Table of Contents
Advertisement
Quick Links
Operating Instructions • Warning Information • Parts Breakdown
™
RL85A
SPECIFICATIONS
Fluid Orifice .......................................................... 1.3mm
Air Inlet: ....................................................................1/4 NPT
G
F
RAVITY
EED
Rec. Max. Inlet Pressure: ..............................................43 PSI
HVLP S
G
PRAY
UN
CFM: .................................................................. 9.6 at 43 PSI
Nozzle Pressure .......................................................... 10 PSI
C
WITH
UP
1
Rev. 03/20/03
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Matco Tools RL85A
Summary of Contents for Matco Tools RL85A
- Page 1 Operating Instructions • Warning Information • Parts Breakdown ™ RL85A SPECIFICATIONS Fluid Orifice ............1.3mm Air Inlet: ..............1/4 NPT RAVITY Rec. Max. Inlet Pressure: ..........43 PSI HVLP S PRAY CFM: ..............9.6 at 43 PSI Nozzle Pressure ............10 PSI WITH Rev.
- Page 2 WARNING - FOLLOW THESE RULES FOR SAFE OPERATION! • During cleaning and flushing, solvents • When possible, secure work with clamps or vise so can be forcefully expelled from fluid both hands are free to operate tool. and air passages. Some solvents can •...
- Page 3 AIR SUPPLY Length of Pipe (ft.) Pitch pipe back toward air receiver Air Flow 1/2" 3/4" 3/4" Compressor Unit Install drain at 3/4" 3/4" 3/4" 3/4" each low point 3/4" 3/4" 1" 1" 1" 1" 1" 1" Oil & Water 1"...
- Page 4 FOR BEST PERFORMANCE, PLEASE BE SURE TO DO THE FOLLOWING BEFORE USING THIS TOOL • Tighten the gun to the cup securely with the nut and fitting supplied. • Be sure to have the proper air pressure at the gun to operate. Proper air pressure for this tool should be 35 PSI for lacquer and 43 PSI for enamel.
- Page 5 OPERATION Proper handling of the gun is essential for obtaining a uniform finish, lap each stroke over the preceding stroke, good finish. The gun should be held at a right angle to making sure the spray is smooth and wet. the surface being covered, and moved parallel with it.
- Page 6 TROUBLESHOOTING SPRAY PATTERN/ PROBLEM SOLUTION CONDITION Soak nozzle in solvent to loosen clog, then blow One side of nozzle wing air through until clean. To clean orifices use a is clogged. broom straw or toothpick. Never try and detach dried material with sharp tool. A.) Loose air nozzle.
- Page 7 PARTS BREAKDOWN - RL85A RL80C 1732 1729AL-1 1730A 1731 9003PKG (10 Pack) 9612N-0 1709 9618 1710 9619 9617 9601 1711 9604 1705 1706 1707 1708 9616 1713 9626 1724A 1714 1733 RLDR10 1722 1715 1720 1725A 1785RK Includes all parts as...
- Page 8 ™ PARTS LIST - RL85A WARRANTY Matco warrants its air tools for a period of 1 year to the consumer. We will repair any air ITEM NO. DESCRIPTION tool covered under this warranty which proves RS1785RK Repair Kit* to be defective in material or workmanship...
Need help?
Do you have a question about the RL85A and is the answer not in the manual?
Questions and answers