Advertisement
Table of Contents
Operating Instructions • Warning Information • Parts Breakdown
™
RL80A
Gravity Feed
SPECIFICATIONS
Spray Gun
Fluid Orifice .......................................................... 1.3mm
Air Inlet: ....................................................................1/4 NPT
and Cup
Rec. Max. Inlet Pressure: ..............................................60 PSI
CFM: ................................................................ 10.1 at 43 PSI
Nozzle Pressure .......................................................... 47 PSI
1
Rev. 03/20/03
Advertisement
Table of Contents
Related Manuals for Matco Tools RL80A
Summary of Contents for Matco Tools RL80A
- Page 1 Operating Instructions • Warning Information • Parts Breakdown ™ RL80A Gravity Feed SPECIFICATIONS Spray Gun Fluid Orifice ............1.3mm Air Inlet: ..............1/4 NPT and Cup Rec. Max. Inlet Pressure: ..........60 PSI CFM: ..............10.1 at 43 PSI Nozzle Pressure ............47 PSI...
- Page 2 WARNING - FOLLOW THESE RULES FOR SAFE OPERATION! • During cleaning and flushing, solvents • When possible, secure work with clamps or vise so can be forcefully expelled from fluid both hands are free to operate tool. and air passages. Some solvents can •...
-
Page 3: Installation
AIR SUPPLY Length of Pipe (ft.) Pitch pipe back toward air receiver Air Flow 1/2" 3/4" 3/4" Compressor Unit Install drain at 3/4" 3/4" 3/4" 3/4" each low point 3/4" 3/4" 1" 1" 1" 1" 1" 1" Oil & Water 1"... - Page 4 FOR BEST PERFORMANCE, PLEASE BE SURE TO DO THE FOLLOWING BEFORE USING THIS TOOL • Tighten the gun to the cup securely with the nut and fitting supplied. • Be sure to have the proper air pressure at the gun to operate. Proper air pressure for this tool should be 35 PSI for lacquer and 43 PSI for enamel.
-
Page 5: Operation
OPERATION Proper handling of the gun is essential for obtaining a uniform finish, lap each stroke over the preceding stroke, good finish. The gun should be held at a right angle to making sure the spray is smooth and wet. the surface being covered, and moved parallel with it. -
Page 6: Troubleshooting
TROUBLESHOOTING SPRAY PATTERN/ PROBLEM SOLUTION CONDITION Soak nozzle in solvent to loosen clog, then blow One side of nozzle wing air through until clean. To clean orifices use a is clogged. broom straw or toothpick. Never try and detach dried material with sharp tool. A.) Loose air nozzle. - Page 7 PARTS BREAKDOWN - RL80A RL80AC 1732 1729AL-1 1730A 1731 9003PKG (10 Pack) 9612N-0 1709 1710 1701 1717 1718 1719 1704 1705 1706 1707 1708 1711 1716 * * * 1713 1726 1724A 1714 1733 1722 1715 1720 1725A 1700RK Includes all parts as...
- Page 8 PARTS LIST - RL80A ITEM NO. DESCRIPTION RS1700RK Repair Kit* RS1701-1.3 Air Nozzle 1.3MM (Standard) WARRANTY RS1704-1.3 Fluid Nozzle 1.3MM (Standard) Matco warrants its air tools for a period of 1 RS1705 Packing Screw year to the consumer. We will repair any air...
Need help?
Do you have a question about the RL80A and is the answer not in the manual?
Questions and answers