Quantum PX502 Introduction Manual page 4

Quantum PX502 Chassis Repacking Instructions
Document 81-81453-02 A01
January 2006
4
3 From the back of the library, disconnect all power, Ethernet, and SCSI
cables from the library and note their locations for later reinstallation.
This unit has more than one power supply cord.
Warning:
Disconnect all power supply cords before servicing to
avoid electric shock.
4 To remove the library chassis from the rack (see
Refer to the PX502 Quick Start Guide (PN 81-81292) for
Note:
additional PX502 rack mount information.
Loosen the captive screws securing the tape drives to the chassis and
a
remove the tape drive(s) from the back of the library.
Loosen the captive screw securing the power supplies to the chassis
b
and remove the power supplies from the back of the library.
Remove PHILLIPS® screws securing each side of the chassis to the
c
rack mounting rails and remove two Allen screws securing both
clamps on the back of the library.
Remove the library from the rack.
d
At least two people are required to move the library
Warning:
chassis.
Removing the Library from the Rack
figure 1):