Table of Contents
Advertisement
10. Using the Wi-Fi function
• Check the wireless access points instruction manual and settings when saving a wireless
access point.
• If no connection can be established, the wireless access point's radio waves may be too
weak.
Refer to "Message Display"
• Depending on your environment, transmission speed between the camera and wireless
access point may decrease. In addition, the wireless access point may not be available for
use.
Connecting the camera and another device directly (direct connection)
You can select the method for connecting to the device you
are using.
Select the connection method supported by your device.
[WPS Connection]
[Manual Connection]
• Please also refer to the operating instructions of the device to be connected.
(P325)
and "Troubleshooting"
[WPS (Push-Button)]
1
On the camera, select [WPS (Push-Button)].
2
Set the device to WPS mode.
• You can wait longer for a connection by pressing [DISP.] on this
unit.
[WPS (PIN code)]
1
On the camera, select [WPS (PIN code)].
2
Enter the PIN code of the device into this camera.
Enter the SSID and password into
the device. The SSID and
password are displayed on the
connection waiting screen of this
unit.
• If the destination is set to
[Smartphone], the password is not
displayed. Select the SSID to establish a connection.
293
(P327)
for details.
(P263)
Advertisement
Table of Contents
