Quantum PX500 Release Note page 4

Release Notes
Document 5502252 Rev C
August 2008
Change Service
Request Request
Number Number
PCR 14723
PCR 14724
PCR 14733 SR: 355614
PCR 16219
PCR 17100
PCR 17370
PCR 17725 SR: 777244
PCR 17847
PCR 18206 SR: 798660
PCR 19001
PCR 19032
PCR 19033
PCR 19034
PCR 19037
PCR 19041
PCR 19042
PCR 19043
PCR 19044
PCR 19045
PCR 19051
PCR 19096
PCR 19116
PCR 19185
PCR 19258 SR: 818050
PCR 19288 SR: 815106
4
If there is a miss-match between the Cartridge Memory (CM) and the element type or
barcode, the system will accept the element type.
Address issues found in Cartridge Memory (CM) reads resulting in invalid densities after
the drive is swapped.
With a bad tape drive, failing unload is taking 45 minutes and it should be 16 minutes.
Improved the error message reported in the Remote Management Pages when the pass-
through elevator test has stopped with an error.
The Remote Management Pages do not reflect the library online state correctly (Java
version 6 issue).
State and Drive Activity fields always display
Public SNMP community cannot be removed.
SCSI Inquiry does not return the library serial number once a partition is named.
The library Remote Management Pages/
status.
The Healthtest does not fail but logs a B506 event in the hard que.
Add a test to move a cartridge from the top to the bottom of a library stack (and back)
A Failed move to the Lower Pass-thru leaves the unit stuck in a Moving state.
Remote Management Pages: Allow more than 15 chars in the Find Media ID area.
Add specific text to failed get cartridge events.
Improved media handling in the pass-through.
Add an SNMP and E-mail event to inform user of a Host Reserve on the library.
The OCP does not notify that the tape drive updated has completed when downgrade
finishes.
OCP: Drive operation screen is not correctly updated after drive power off.
Prevents the Pass-through Elevator and the Hand can becoming FULL at the same time
when moving tape cartridges from the Remote Management Pages
The left door is opening up during power-on on some PX502 backplanes.
Improve message if a user hits remove when no partition is selected/available.
The WWNN need to be unique for each partition like SN - Networker autoconfig fails.
Configuration of partitions is allowed (when it shouldn't be) with a Parallel SCSI or iSCSI
library.
The library goes into an unexpected error state and the date and time are incorrect.
Allow the library to configure drives if drive found after the configuration process.
Resolved Issues
Description
.
unknown
does not report the correct
Setup SCSI/Fibre