Lexus SC 430 2004 Manual page 243

STARTING AND DRIVING
D Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
D Consult the dealer or an experienced radio / TV
technician for help.
FCC WARNING:
Changes or modifications not expressly approved
by the party responsible for compliance could void
the user's authority to operate the equipment.
For vehicles sold in Canada
Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation of the
device.
224
Replacing tires and wheels
As you might have difficulty in locating a flat or deflated
tire, an tire pressure warning system should be installed
on the tires of this vehicle.
When replacing the wheels, be sure to install tire pressure
sensors on the wheels.
There are 3 ways to set up the tire pressure sensors:
a. Remove the sensor from the old wheel and install it to the
new wheel.
b. Keep the same wheel with tire pressure sensor and replace
the tire alone.
c. Use a new wheel and sensor.
You have to register an ID code for a new sensor. Up to 2
sets of codes can be registered. As one ID for the originally
installed sensor is registered at "MAIN" of the selector
switch, use the "2nd" position to register an ID for the new
sensor.
You do not need to re-register the ID code for any other
replacements. For the use of the originally installed tires,
put the selector switch at "MAIN" and for the use of tires set
purchased later, put the switch at "2nd". For the sensor
selector switch, see page 225.