Bushnell TROPHY CAM HD VITAL 119726C Instruction Manual page 16

until the Field Scan "A" recording block stops at 8:00 AM. Later that day,
the camera would again take a photo or video every 15 minutes between
5:30 PM and 7:00 PM (during Field Scan time block "B"). The next day,
the camera would again record an image or video once every 15 minutes
between 6:00 and 8:00 AM, and between 5:30 and 7:00 PM. No Field
Scan recording would occur from 8AM to 5:30PM, or from 7PM to 6AM.
Remember, Field Scan recording is independent of normal triggers due to
animal activity–even if no animals enter the IR sensor coverage zone, an
image or video will still be captured every 15 minutes during the block(s) of
time. If an animal triggers the camera "in between" the 15 minute intervals,
it will be recorded, same as it would if you had setup the camera with Field
Scan turned Off. Note: Field Scan settings of frequent intervals and/or
long periods between start and stop time can reduce battery life.
(Step 1)-set Field
Scan Mode to "On"
Steps 4 & 5 are
optional (only
required if you want
to set up a second
block of Field Scan
recording with
different stop and
start times)
Note: the Interval
Setting sets the
timing between each
image for both Field
Scan "A" and "B"
recording blocks.
16
select Field
(Step 2) -
Scan "A" (press OK)
(Step 4) (opt)-select Field
Scan "B" (press OK)
(Step 6)-select Field
Scan "Interval"
set Field
(Step 3) -
Scan "A" Stop & Start
-set Field
(Step 5)
(opt)
Scan "B" Stop & Start
set Field
(Step 7) -
Scan Interval