Quantum DLT S4 User Manual page 10

Notational Conventions
2U Rackmount Component Replacement Guide
• Chapter 8, Rear-Panel CAT 6 Cable Connector Plate
replace the CAT 6 cable connector plate in units that use an
SDLT 600A tape drive.
• Chapter 9, Ethernet Cable
in units that use an SDLT 600A tape drive.
• Chapter 10, LED Cable Assembly
cable assembly.
• Appendix A, SCSI ID and Connections
SCSI ID on the 2U Rackmount and how to connect the tape drives as a
single device and as a daisy chain.
• Appendix B, Troubleshooting
2U Rackmount issues.
This manual uses the following conventions:
Notes emphasize important information related to the main
Note:
topic.
Tech Tips provide technical information which may be
Tech Tip:
helpful in performing the procedure.
Cautions indicate potential hazards to equipment and are
Caution:
included to prevent damage to equipment.
Warnings indicate potential hazards to personal safety and
Warning:
are included to prevent injury.
This manual uses the following:
• Right side — Refers to the right side as you face the component being
described.
• Left side — Refers to the left side as you face the component being
described.
describes how to replace an Ethernet cable
describes how to replace an LED
describes how to change the
describes how to troubleshoot basic
Preface
describes how to
x