Table of Contents
Advertisement
Description
5 A groove has been formed in the base
metal adjacent to the toe of a weld
and has not been filled by the weld
metal (undercut).
0-5592
OPERATING MANUAL
Possible Cause
A Welding current is too high.
B Welding arc is too long.
C Angle of the electrode is
incorrect.
D Joint preparation does not
allow correct electrode angle.
E Electrode too large for joint.
F Insufficient deposit time at
edge of weave.
Art # A-07714
Figure 5-31: Examples of undercut
5-13
WeldSkill MicroArc 140
Remedy
A Reduce welding current
B Reduce the length of the
welding arc
C Electrode should not be
inclined less than 45° to the
vertical face
D Allow more room in joint
for manipulation of the
electrode.
E Use smaller gauge
electrode.
F
Pause for a moment at
edge of weave to allow weld
metal build-up.
OPERATION
Advertisement
Table of Contents
