Figure 6. Locations Of Scsi Interface And Power Connectors On The Internal Drive - Certance DAT 24 User Manual

Installation
Connecting Power and Interface Cables
Attach the power and SCSI interface cables to the appropriate connectors on the back of the drive.
Figure 6 on page 17 shows the locations of these connections.
Connecting the SCSI Interface Cable
Turn off all power to the drive and host computer. Attach the SCSI cable, making sure to align pin 1
on the cable with pin 1 on the drive. Pin 1 on the SCSI connector is to your right as you look at the
back of the drive (see Figure 6). Your SCSI cable should have pin 1 highlighted by a colored stripe.
Connecting the Power Cable
Attach a 4-pin power connector from the system power supply to the connector on the back of the
drive. The recommended 4-pin power connector for the internal drive is an AMP 1-48024-0 housing
with AMP 60617-1 pins or equivalent.

Figure 6. Locations of SCSI Interface and Power Connectors on the Internal Drive

4-pin
power
connector
SCSI pin 1
SCSI connector
Installing an Internal DAT24 Drive
17