Threading The Upper Looper - Singer S0700 Instruction Manual

Threading the Upper Looper

Turn off the main power switch and unplug the machine.
Note: Raise the presser foot lifter for easier threading.
Place a thread spool on the second right spool pin. Pull
the thread through the second right thread guide from
back to front (A).
Note: If the thread tends to slip away from the guide
while sewing, pass the thread through both thread guide
holes as shown (B).
Slide the thread under the top cover thread guide (C) as
illustrated.
Pull the thread along the threading slit. Using both hands,
insert the thread between the disks (D).
Set the lower looper pre-tension setting slider (E) to
NORM.
Pull the thread down along the slit and into the upper
looper thread guide (F).
Pull out approximately 12˝ (30 cm) of thread. Make sure
that the thread does not get tangled around the lever or
the cover.
16 – GETTING READY TO SEW
L
M
A
C
E
A
B
C
D
E
F
J
I
K
G
B
D
F
H