Table of Contents
Advertisement
Connecting the Foot Control
and the Power Supply
Foot control to use with this machine:
Type C-1028 for USA/Canada, C-2085-1 for U.K., C-2065
for Australia, C-2060 for Continental Europe.
Before plugging your machine in, make sure the voltage is
the same as indicated on the lower rear side of the machine.
Specifications vary from country to country.
•
Connect the foot control/electric power cord to the sock-
et on the machine (A).
•
Plug the power cord plug into the electric outlet (B).
•
Push the power switch (C) to "I" to turn on the machine.
•
Press the foot control to start sewing (D). Use the foot
control to adjust the sewing speed. The harder you press,
the faster the machine will sew.
•
To stop the machine from sewing, remove your foot
from the control.
•
Push the power switch to "0" to turn off the machine.
Note: When the front cover and/or the flat bed extension cov-
er is/are opened, the safety switch is activated and prevents
the machine from sewing, even if the foot control is pressed.
The machine will also be prevented from sewing when the
foot is raised.
Note: Your overlock machine is adjusted to provide the best
stitch result at normal room temperature. Extreme hot and
cold temperatures can affect the sewn result.
Before Using Your Machine
for the First Time
Before using your machine for the first time, place a scrap
of fabric under the presser foot and run the machine without
thread for a few minutes. Wipe away any oil which may ap-
pear.
Setting Up the Telescopic Thread Stand
Extend the telescopic thread stand to its full height, then turn
until it clicks into place.
If the machine is already threaded, straighten the threads to
prevent tangling.
C
D
POLARIZED PLUG INFORMATION
(FOR U.S.A. & CANADA ONLY)
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of electric shock, this plug
is intended to fit in a polarized outlet only way. If the
plug does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician to install
the proper outlet. Do not modify the plug in any way.
A
B
ABOUT YOUR MACHINE – 7
Advertisement
Table of Contents
