Tripp Lite B127U-111-PDPD Owner's Manual page 9

Installation
Application Diagram
1x2 DisplayPort Spli er
USB Power
Adapter
4K/60Hz Source
1. Make sure all equipment in the installation – such as TVs,
Blu-ray players and the transmitter – is powered off.
2. Connect the pigtail DisplayPort connector on the transmitter
unit to the DisplayPort input on the source.
3. Using Cat6 cable, connect the RJ45 ports on the local
transmitter unit to the RJ45 input ports of each remote
receiver unit.
4. Connect the pigtail DisplayPort connector on the remote
receiver units to the DisplayPort input ports of each display.
5. Connect the pigtail USB-A connector on the local
transmitter unit to a USB power adapter and into a wall
power outlet. The LED next to the RJ45 port should
illuminate to indicate the unit is receiving power.
DisplayPort Transceiver
USB Power USB Power
Adapter Adapter
4K or 1080p
TV
up to 230 up to
24AWG Cat6 Cable 24AWG Cat6 Cable
DisplayPort Transceiver
USB Power USB Power
Adapter Adapter
4K or 1080p
TV
up to 230 up to
24AWG Cat6 Cable 24AWG Cat6 Cable
9
DisplayPort Transceiver HDMI Transceiver
USB Power
Adapter
4K or 1080p 4K or 1080p
TV
230 up to 230
24AWG Cat6 Cable
DisplayPort Transceiver HDMI Transceiver
USB Power
Adapter
4K or 1080p 4K or 1080p
TV
230 up to 230
24AWG Cat6 Cable
TV
TV