IBM xSeries 220 Hardware Maintenance Manual page 127

Error Code/Symptom
185
(Drive startup sequence
information corrupted)
186
(Security hardware control
logic failed)
187
(VPD serial number not set.)
188
(Bad EEPROM CRC #2)
189
(Three attempts were made to
access the server with invalid
passwords)
201
(Memory test error, see
"Memory Settings" on page
32.) If the server does not
have the latest level of BIOS
installed, update the BIOS to
the latest level and run the
diagnostic program again.
229
(Cache error)
289
(DIMM has been disabled by
user or system, see "Memory
Settings" on page 32.)
301
(Keyboard or keyboard
controller error)
303
(Keyboard controller error)
602
(Invalid diskette boot record)
604
(Diskette drive error)
662
(Diskette drive configuration
error)
1. Run Configuration/Setup
2. System Board
1. Run Configuration/Setup
2. System Board
1. Set serial number in Setup
2. System Board
1. Run Configuration/Setup
2. System Board
1. Run Configuration/Setup, enter the administrator password
2. System Board.
1. Run memory diagnostics.
2. DIMM
3. System Board
1.
Microprocessor
2. Optional microprocessor (if installed)
1. Run Configuration/Setup, if disabled by user
2. Disabled DIMM, if not disabled by user.
1. Keyboard
2. System Board
1. System Board
2. Keyboard
1. Diskette
2. Diskette Drive
3. Cable
4. System Board
1. Run Configuration/Setup and Diagnostics
2. Diskette Drive
3. Drive Cable
4. System Board
1.
Run Configuration/Setup and Diagnostics
2. Diskette Drive
3. Drive Cable
4. System Board
FRU/Action
Symptom-to-FRU index
121