Bosch F.01U.299.030 Operation Manual page 49

Digital Discussion System
–
–
Notice!
When the system is reset to the factory defaults, the latest version of the software that the
system was upgraded to will be maintained.
Recorder (CCSD‑CURD only)
Click the Recorder button to open the recorder settings page.
The following recorder settings are available:
–
–
–
Seats
Click the Seats button to open the seat settings page.
Here the seat settings for the Discussion Devices can be configured:
–
Bosch Security B.V.
– Hostname: The default hostname is CCS1000D
Note: When changing the hostname or (de)activating the fixed IP address in the web
browser interface (see below), the laptop/PC might lose the connection with the
Control Unit. If this happens, close and then re-open the web browser interface.
Wired:
– Fixed IP: Select this checkbox if you want to use a fixed IP address. The fields below
change from grey to white to indicate that they are activated.
– IP address: Enter a valid IP address.
– Subnet mask: Enter a valid subnet mask.
– Default gateway: Enter a valid default gateway.
General settings:
– Automatically shutdown the system when not used (energy saving mode): When
selected, the control unit is automatically shut down when it is not used for two
hours. The 'waiting list' and 'speakers list' are automatically saved, and will be
available when the system is powered on.
Note: This feature does not apply to the voice activation mode.
– Factory default: Click the factory default button to reset all system settings and
values to the factory defaults.
Source: Select which audio source must be recorded:
– Floor only: The audio of the floor discussion language is recorded.
– Floor and output 3, 4, 5, 6: The audio of the floor discussion language and selected
audio output signal (3-6) are mixed and recorded.
Bit rate: Select the recording audio quality (from 64 kbps (lowest) up to 256 kbps
(highest)).
Automatically pause recording when all microphones are switched off: Recording is
paused when no microphone is active.
Seats overview:
– (x-y): x = number of Discussion Devices currently connected to the system and
initialized. y = historical number of Discussion Devices connected to the system.
Click one of the square icons on the left of this page to locate a Discussion Device in
the meeting room. When a tick is displayed in the checkbox, the light‑ring indicator
in the corresponding microphone is lit red and the LED indicator above the
microphone button flashes.
Note: This is only possible when the Selection mode checkbox at the left bottom of
the page is selected.
Operation manual
Configuration | en 49
2020.05 | V2.2 |