Table of Contents
Advertisement
1886
Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Partially install two of the light kit screws
found in the
bag. It does not matter
which two screw holes you choose. Connect
the single-pin connectors from the LED
assembly to the connectors from the fan.
Connect the white wires together. Connect
the blue and black wires together.
Notch
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
9
Ceiling Bracket
Downrod
Assembling the LIght Kit
2 of 6
Light Kit Screw
bag
2 of 6
Light Kit Screw
bag
Align the keyhole slots in the light kit
housing with the two screws. Make
sure all the wires from the fan and the
light kit are snug inside the center of
the light kit, not pinched in between
the upper switch housing and the light
kit or hanging out of the sides.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
Installing the Glass
Tab
Note:
Fan style may vary.
Hanging Fan
Wiring
Feed the wire plug through the
center hole of the upper switch
housing, then wrap keyhole
slots around the screws and
twist counterclockwise.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
NOTE: Check to ensure
proper engagement.
Canopy
Blades
Insert the third screw,
found in the
hardware
bag, into place and then
tighten all three screws.
Turn the light kit counterclockwise until the
light kit screws are firmly situated in the
narrow end of the keyhole slots. Install the third
screw and tighten all three screws securely.
Note:
Fan style may vary.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Light
Remote
1 of 6
Light Kit Screw
bag
1 of 6
Light Kit Screw
bag
Troubleshooting
Advertisement
Table of Contents
