Installing Hardware Options For The Wave-7541, Wave-7571, And Wave-8541; Installing A Cisco Wave Interface Module - Cisco 7541 Hardware Installation Manual

Installing Hardware Options for the
WAVE-7541, WAVE-7571, and WAVE-8541
This chapter provides basic instructions for installing hardware options in your WAVE-7541,
WAVE-7571, and WAVE-8541. These instructions are intended for technicians who are experienced with
setting up Cisco WAVE-7541, WAVE-7571, and WAVE-8541 hardware.
This chapter contains the following sections:
•
•
•
•

Installing a Cisco WAVE Interface Module

In addition to the two onboard Gigabit Ethernet ports, the WAVE-7541, WAVE-7571, and WAVE-8541
can accommodate one optional Interface Module:
•
•
•
•
For information on the features of the Cisco WAVE Interface Modules and cabling requirements, see
Chapter 5, "WAVE Interface Modules."
Note
Interface Modules are not hot-swappable therefore it is necessary to power the system down before
installing or replacing.
Caution
To maintain proper system cooling, do not operate the appliance for more than 1 minute without either
a Cisco Interface Module or a filler panel installed in the bay.
To install a Cisco Interface Module in the Interface Module slot, follow these steps:
Installing a Cisco WAVE Interface Module
Replacing a Hard Disk Drive/Solid State Drive
Replacing a Fan
Replacing a Power Supply
4-port Gigabit Ethernet Copper Bypass Interface Module
8-port Gigabit Ethernet Copper Bypass Interface Module
4-port Gigabit Ethernet Fiber Optic Bypass Interface Module
2-port 10 Gigabit Ethernet Fiber Optic SPF+ Interface Module
Cisco Wide Area Virtualization Engine 7541, 7571, and 8541 Hardware Installation Guide
4
C H A P T E R
4-1