WAVE Interface Modules
This chapter describes the Cisco WAVE Interface Modules .
This chapter contains the following sections:
•
•
•
•
For information on installing an inline adapter in your WAVE-7541, WAVE-7571, and WAVE-8541, see
Installing a Cisco WAVE Interface Module
WAVE-7541, WAVE-7571, and WAVE-8541."
For adapter specifications, see
Interface Module Descriptions
The WAVE appliance supports one optional 4-port Copper Gigabit Ethernet Interface Module, 8-port
Copper Gigabit Ethernet Interface Module, 4-port Fiber Optic Gigabit Ethernet Interface Module, or
2-port SFP+ Fiber Optic 10 Gigabit Ethernet Interface Module.
This section contains the following topics:
•
•
•
•
Gigabit Ethernet Interface Module—Copper
The copper Gigabit Ethernet Interface Module is available in 4 or 8 ports. Both models support bypass.
(See
Interface Module Descriptions
Ports and LED Indicators
Network Adapter Cabling Requirements
Installation Scenarios and Cabling Examples for Fast Ethernet Connections
Gigabit Ethernet Interface Module—Copper
Gigabit Ethernet Interface Module—Fiber Optic
10 Gigabit Ethernet Interface Module—Fiber Optic SFP+
Inline Interface
Figure 5-1
and
Figure
5-2.)
Cisco Wide Area Virtualization Engine 7541, 7571, and 8541 Hardware Installation Guide
C H A P T E R
in Chapter 4, "Installing Hardware Options for the
Table A-2
in Appendix A.
5
5-1