Table of Contents
Advertisement
13. Unplug this product from the wall outlet and refer servicing to qualified service personnel under
the following conditions:
a. When the power cord or plug is damaged or frayed.
b. If liquid has been spilled into the product.
c. If the product has been exposed to rain or water.
d. If the product does not operate normally when the operating instructions are followed. Adjust
only those controls that are covered by the operating instructions since improper adjustment
of other controls may result in damage and will often require extensive work by a qualified
technician to restore the product to normal condition.
e. If the product has been dropped or the cabinet has been damaged.
f.
If the product exhibits a distinct change in performance, indicating a need for service.
14. Use only the proper type of power supply cord set (provided in your accessories box) for this unit.
It should be a detachable type: UL listed/CSA certified, BS1363, ASTA, SS145 certified, rated
10A 250V minimum, VDE approved or its equivalent. Maximum length is 15 feet (4.6 meters).
15. NOTE:
Please take extra precaution when connecting the LAN cable; do not connect the LAN cable
to the peripheral device's connector, that might have excessive voltage.
16. CAUTION.
If the CD/DVD drive is not operated correctly according to the instructions or procedures
specified in the operating manual, it may emit a laser beam. Disassembling the CD/
DVD drive may cause you to be exposed to a harmful laser beam. So never disassemble
it. The CD/DVD drive may emit a Class 3A or Class 3B laser beam when its cover is
detached.
The CD/DVD drive may emit a Class 3A or Class 3B laser beam when its cover is
detached. Do not look at the laser beam directly or through an optical device. Also, be
careful not to be exposed to the laser beam.
Safety of Laser Products
The CD/DVD drive installed on your computer uses a laser.
Class 1 Laser Products
The CD/DVD drive complies with the provisions pertinent to class 1 laser products, in Subchapter
J of the Federal Regulation DHHS 21 CFR of the United States Department of Health and Human
Services. Also, it complies with the international standard IEC 60825-1, the CENELEC standard
EN 60825-1 and the Japanese standard JIS C6802, which govern Class 1 laser products.
Koror 0(INTRO)
3
12/5/05, 5:03 PM
iii
Advertisement
Table of Contents
