Husqvarna 520iLX Operator's Manual page 10

2. Push the power trigger lockout forward (A) and
down. Hold the power trigger lockout against the
handle (B) and make sure that it returns to its
original position when you release it.
3. Make sure that the power trigger and the power
trigger lockout moves freely and that the return
springs operate properly.
4. Start the product, refer to
page 12 .
5. Push the power trigger fully to apply full speed.
6. Release the power trigger and make sure that the
cutting attachment stops and remains still.
To do a check of the cutting attachment guard
WARNING: Do not use a cutting attachment
without an approved and correctly attached
cutting attachment guard. Always use the
recommended cutting attachment guard for
the cutting attachment that you use, see
Accessories on page 18 . If an incorrect or
faulty cutting attachment guard is attached
this can cause serious personal injury.
The cutting attachment guard stops objects that ejects in
the direction of the operator. It also prevents injuries that
occur if you touch the cutting attachment.
1. Stop the motor.
2. Do a visual check for damages, for example cracks.
756 - 003 - 24.06.2020
B
A
To start the product on
3. Replace the cutting attachment guard if it is
damaged.
Battery safety
WARNING: Read the warning instructions
that follow before you use the product.
• Only use the BLi200 battery. Refer to
on page 17 . The battery is software encrypted.
• Use the BLi200 battery that is rechargeable as a
power supply for the related Husqvarna products
only. To prevent injury, do not use the battery as a
power supply for other devices.
• Risk of electrical shock. Do not connect the battery
terminals to keys, coins, screws or other metal. This
can cause a short circuit of the battery.
• Do not use non-rechargeable batteries.
• Do not put objects into the air slots of the battery.
• Keep the battery away from sunlight, heat or open
flame. The battery can cause burns and/or chemical
burns.
• Keep the battery away from microwaves and high
pressure.
• Do not try to disassemble or break the battery.
• If the battery leaks, do not let the liquid touch your
body or eyes. If you have touched the liquid, clean
the area with a large quantity of water and soap, and
get medical aid. If you get liquid in your eyes, do not
rub but flush with water for a minimum of 15 minutes
and get medical aid.
• Use the battery in temperatures between -10 °C (14
°F) and 40 °C (114 °F).
• Do not clean the battery or the battery charger with
To clean the product, the battery and
water. Refer to
the battery charger on page 14 .
• Do not use a defective or damaged battery.
• Keep batteries in storage away from metal objects
such as nails, screws or jewelry.
• Keep the battery away from children.
Battery charger safety
WARNING: Read the warning instructions
that follow before you use the product.
• Risk of electrical shock or short circuit if the safety
instructions are not obeyed.
• Use an approved grounded mains socket that is not
damaged.
• Do not use other battery chargers than the one
supplied for your product. Only use QC330 chargers
when you charge BLi200 replacement batteries.
• Do not try to disassemble the battery charger.
• Do not use a defective or damaged battery charger.
Technical data
9