Programme Follow-Up; Cancelling The Programme; Salt Indicator; Rinse Aid Indicator - Beko TATA VOLTAS DF14W User Manual

Operating the product

Programme follow-up

You can track the current step of the
selected programme on the programme step
lights located on the control panel.
C
If the drying light is on, the
machine will perform silent
drying for 30-60 minutes. At the
end of this period, the Drying
light will go off and the End light
will become on.
The End light will become on when the
selected washing programme ends.

Cancelling the programme

1. Press and hold the Start / Pause /
Cancel key for 3 seconds to cancel the
programme.
2. Release it when the Washing and
Drying lights start flashing. Water in
the machine will be discharged in 45
seconds. The programme will have been
cancelled once the Washing and Drying
lights go off and the End light becomes
on. Then, you can select and operate a
new programme.
C
There might be residues of
detergent or rinse aid left in the
machine and/or on the pieces
being washed depending on the
step in which the programme
has been cancelled.
C
When you set the Programme
Selection Knob to "Off" position,
the washing programme will end
and the machine will be ready
for a new programme selection.
If you end the washing cycle this
way, water and detergent may
remain in the machine.
Dishwasher / User's Manual

Salt indicator

Please check the salt indicator to see
whether there is adequate amount of
softening salt in the dishwasher or not. You
need to refill the salt reservoir with salt
whenever the no-salt warning symbol lights.
C
Adjusting the water hardness
level is explained in Water
Softening System section.

Rinse Aid indicator

Please check the rinse aid indicator to see
whether there is adequate amount of rinse
aid in the dishwasher or not. You need to
refill the rinse aid dispenser with rinse aid
whenever the no rinse aid warning symbol
lights.
Adjusting the amount of
rinse aid
1. While the Programme Selection Knob
is in "Off" position, press and hold the
function key and turn the Programme
Selection Knob clockwise by one level,
keeping the function key pressed for
2 seconds. At the end of this time,
the machine will enter the rinse aid
adjustment mode.
2. Once the machine has entered the
rinse aid adjustment mode, the stored
rinse aid level will be shown on the
programme follow-up LEDs for 5
seconds.
3. For the new Rinse Aid setting, set the
Programme Selection Knob to the
relevant position.
4. Press Start / Pause / Cancel key for once
to store the level you have selected.
5. When you set the Programme Selection
Knob to the "Off" position again, the
machine will enter the normal mode.
31 / 44 EN