Beko TATA VOLTAS DF14W User Manual page 14

Preparation
Unpack the test
Open the tap and
strip.
let the water flow for
approx. 1 minute.
After detecting the water hardness:
1. Move the programme selection knob to position 1 when the machine is turned off.
2. Press the Start/Pause/Cancel key.
3. Press On/Off key while keeping the Start/Pause/Cancel key pressed to turn the machine
on. Do not release the Start/Pause/Cancel key until "Water Hardness Level" set appears on the
indicator of the machine (See. Water Hardness Level Adjustment Table).
4. The default "Water Hardness Level" will remain lit on the panel of the machine for about 5
seconds. Release the Start/Pause/Cancel key after the default "Water Hardness Level" appears.
5. To adjust the new Water Hardness Level, move the programme selection knob to the position
that is suitable for your supply water. (See. Water Hardness Level Adjustment Table)
*Programme Selection knob rotates in 5 steps regardless of the number of the programmes
contained on the machine.
6. Press "Start/Pause/Cancel" key for once to store the level you have selected. After storing
the new setting, turn the Programme Selection knob to "Off" to switch the product to normal
operation mode.
Water hardness level adjustment table
Hardness English Water
Level Hardness °dE
Level 0
0-5
Level 1
6-9
Level 2
10-15
Level 3
16-19
Level 4
20-24
Level 5
25-62
If the hardness level of the water that you use is above 50°dH or if you are using well water,
than it is recommended to use filter and water purification devices.If the hardness level of the
water that you use is below 7°dH, there is no need to use salt in your dishwasher. In this case,
the Salt Indicator light on the control panel of your dishwasher will light continuously.
If the water hardness is set to level 1, the Salt Indicator will light continuously although it is not
Dishwasher / User's Manual
Dip in the test strip
into the water for 1
second.
German Water French* Water
Hardness °dH Hardness °dF
0-4 0-8
5-7 9-13
8-12 14-22
13-15 23-27
16-19 28-34
20-50 35-90
Take out the strip Wait for 1 minute.
from the water and
shake it.
Position of
programme
Water Hardness Level Indicator
selection
knob*
1
Washing lamp on the panel will illuminate.
1
2 Drying lamp on the panel will illuminate.
3 End lamp on the panel will illuminate.
Washing, Drying and End lamps on the
4
panel will illuminate.
Washing, Drying and End lamps on the
5
panel will flash at 1-second intervals.
Make the necessary
adjustment
according to the test
strip.
13 / 44 EN