Barox RY-LGSP28-52 Series Operating Instructions Manual page 54

The example shows the setting of the following values for a new configuration:
- Trap Config Name -> A name should be allocated
Trap Mode -> UDP or TCP – As usual UDP should be used for a start
-
- Trap Version -> Selection of SNMP v2c
- Trap Community -> The previously generated community name must be entered here
- Trap Destination Address -> Entry of the IP address of the trap recipient
- Trap Destination Port -> Entry of the port at the recipient
- Further settings can be assumed from the default settings
Following this the settings are confirmed by clicking "Apply".
barox Kommunikation 54