Page 1
50 Kanalflakt Way, Bouctouche, NB, E4S 3M5 Tel.: 800.565.3548 • Fax: 877.747.8116 Fantech reserves the right to modify, at any time and without notice, any or all of its products’ features, designs, components and specifications to maintain their technological leadership position.
Fresh incoming air is tempered by the heat that is transferred from the outgoing air so you save on energy costs. Fantech HRVs are equipped with automatic defrost mechanisms so Exhaust Air to Fresh Air to...
Fantech HRVs are designed to run continously or intermittently, giving the homeowner complete control over their air quality. Continuous low speed ventilation is recommended, which will help eliminate carbon dioxide, VOCs and other gases as well as freshen up the home. Intermittent high speed ventilation can be obtained through a variety of optional remote controls found in this manual.
In order to activate HIGH speed, a jumper must be placed between the DEHUM + and DEHUM - contacts. 1. Continuous Ventilation Mode 2. Intermittent / Standby Mode (SHR(D) / VHR Series of HRVs) In this mode of operation, both fans are operating and exchanging air The system is always on standby and operates at high speed when with the outside.
Low Voltage Control Systems * Please see instruction manuals for individual controls for proper wiring and set up of control systems. – CENTRAL CONTROLS These control options can only be used individually CONTROLS FEATURES CONNECT TO ECO-Touch • Our most complete, yet easy to use control system •...
Maintenance MAKE SURE UNIT IS UNPLUGGED BEFORE ATTEMPTING ANY MAINTENANCE WORK The following components should also be inspected regularly and well maintained. Filters need to be checked regularly Filters The filters (2) need to be checked and cleaned every three months or when they appear dirty. Wash in warm sudsy water (mild detergent) or use a soft •...
Troubleshooting Problem Causes Solutions Air is too dry Dehumidistat control is set too low Increase the desired level of humidity. Change ventilation mode from continuous mode to standby. HRV out of balance Have contractor balance HRV airflows Air is too humid Dehumidistat control is set too high Reduce the desired level of humidity.
Lines the beginning of the warranty period. Vacuum the Inside of the Annually • The fans found in all Fantech HRVs Unit require no lubrication, and are factory balanced to prevent vibration Clean and Un-block Annually and promote silent operation.
Page 11
50 Kanalflakt Way, Bouctouche, NB, E4S 3M5 Tél.: 800.565.3548 • Fax: 877.747.8116 Fantech se réserve le droit de modifier partiellement ou entièrement, en tout moment et sans préavis, les caractéristiques, la conception, les composants et les spécifications de ses produits, afin de conserver sa position de leader de technologie.
Page 12
DIAGRAMME D’ENTRETIEN DU VRC ............. . 19 La nomenclature chez Fantech...
Air vicié Air frais évacué à distribué à coûts d’énergie. Les VRC de Fantech sont munis d’un mécanisme de l’extérieur l’intérieur dégivrage automatique, ce qui vous permet d’utiliser votre VRC à l’année même si vous habitez dans un climat très froid.
VRC utilise l’air vicié évacué pour refroidir l’air frais entrant. Les VRC de Fantech sont conçus de manière à fonctionner de façon continue ou intermittente, ce qui permet au propriétaire des lieux de contrôler entièrement la qualité de l’air de son environnement. Une ventilation continue à basse vitesse est recommandée; celle-ci facilite l’élimination du gaz carbonique, des contaminants organiques volatils (COV) et des autres gaz tout en purifiant l’air ambiant.
Modes d’opération Le commutateur sur le côté de l’appareil sert à basculer entre les modes ATTENTE, BASSE vitesse et MOYENNE vitesse. Afin d’activer la HAUTE vitesse, un cavalier doit être placé entre les contacts DEHUM + et DEHUM -. 1. Mode de ventilation continu 2.
Système de contrôle à basse tension * Veuillez voir les instructions individuelles des contrôles pour le câblage et la mise en pièce appropriée. – CONTRÔLES CENTRALS Ces options de contrôle peuvent seulement être utilisé individuellement CONTRÔLE CARACTÉRISTIQUES CONNEXION À ECO-Touch •...
Entretien ASSUREZ-VOUS QUE L’APPAREIL EST DÉBRANCHÉ AVANT D’ENTREPRENDRE TOUTE TÂCHE D’ENTRETIEN. Il est important d’inspecter régulièrement les composants suivants et de bien les entretenir. Les filtres doivent être vérifiés régulièrement Filtres Les filtres (2) doivent être vérifiés et nettoyés à chaque trois mois ou quand ils ont l’air.
Dépannage Problème Causes Solutions L’air est trop sec – Le déshumidistat est réglé trop bas – Augmentez le niveau voulu d’humidité. Faites passer le mode de ventilation de « continu » à « attente ». – Le VRC est déséquilibré –...
à proximité du domicile de l'acheteur ou dans sa région. • Fantech se réserve le droit de fournir des pièces remises à neuf comme pièces de rechange. • Les frais de transport, de retrait et d'installation sont assumés par...
Page 20
Fantech reserves the right to make technical changes. Fantech se réserve le droit de faire des changements tech- For updated documentation please refer to www.fantech.net niques. Pour de la documentation à jour, s'il vous plaît se référer au www.fantech.net Fantech®...
Need help?
Do you have a question about the VHR Series and is the answer not in the manual?
Questions and answers