Daikin Altherma F Installer's Reference Manual page 220

10 | Configuration
Installer reference guide
220
c Smartphone + app
Configuration
To configure the Daikin Residential Controller app, follow the in-app instructions.
While doing this, the following actions and information are needed on the user
interface:
Mode: Turn AP mode ON (= WLAN adapter active as access point) or OFF.
# Code
[D.1] N/A
Reboot: Reboot the WLAN cartridge.
# Code
[D.2] N/A
WPS: Connect the WLAN cartridge to the router.
# Code
[D.3] N/A
INFORMATION
You can only use this function if it is supported by the software version of the WLAN,
and the software version of the Daikin Residential Controller app.
Remove from cloud: Remove the WLAN cartridge from the cloud.
# Code
[D.4] N/A
Home network connection: Read out the status of the connection to the home
network.
# Code
[D.5] N/A
Cloud connection: Read out the status of the connection to the cloud.
The Daikin Residential Controller app needs to be
installed on the user's smartphone. See:
http://www.onlinecontroller.daikineurope.com/
Description
Enable AP mode:
▪ No
▪ Yes
Description
Reboot the gateway:
▪ Back
▪
OK
Description
WPS:
▪ No
▪ Yes
Description
Remove from cloud:
▪
No
▪ Yes
Description
Home network connection:
▪ Disconnected from [WLAN_SSID]
▪ Connected to [WLAN_SSID]
EPRA14~18DAV3+W1 + ETVH16SU18+23EA6V
Daikin Altherma 3 H HT F
4P644738-1 – 2021.02