Table of Contents
Advertisement
3.6.8
APM Configuration
ErP Ready [Disabled]
This item allows you to switch off some power at S4+S5 or S5 to get the system ready for
ErP requirement. When set to [Enabled], all other PME options are switched off.
Configuration options: [Disabled] [Enabled (S4+S5] [Enabled (S5)]
Restore AC Power Loss [Power Off]
This item allows your system to go to ON state, OFF state, or both states after an AC power
loss. When setting your system to [Last State], it goes to the previous state before the AC
power loss.
Configuration options: [Power Off] [Power On] [Last State]
Power On By PCI-E/PCI [Disabled]
This item allows you to enable/disable the Wake-on-LAN function of the onboard LAN
controller or other installed PCI-E LAN cards.
Configuration options: [Disabled] [Enabled]
Power On By RTC [Disabled]
This item allows you to enable/disable the RTC (Real-Time Clock) to generate a wake event
and configure the RTC alarm date. When enabled, you can set the days, hours, minutes, or
seconds to schedule an RTC alarm date.
Configuration options: [Disabled] [Enabled]
Chapter 3: BIOS Setup
3-46
E13611_X99-E_WS_USB31_UM_V4.indb 46
10/27/2017 16:56:17
Advertisement
Table of Contents
