Makita GRU02 Instruction Manual page 11

To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided. To start the tool,
depress the lock-off lever and pull the switch trigger.
The tool speed increases by increasing pressure on the
switch trigger. Release the switch trigger to stop.
GRU02
2
► 1. Lock-off lever 2. Switch trigger
GRU03
2
► 1. Lock-off lever 2. Switch trigger
NOTE: Always depress the lock-off lever and pull the
switch trigger to run the tool. In the following cases,
the main power switch turns off automatically:
— When both the lock-off lever and switch trigger
are released.
— When the lock-off lever is released for 1 second.
— When the lock-off lever is not depressed within
45 seconds after the main power switch is
turned on.
— When the switch trigger is not pulled for 60 sec-
onds while the lock-off lever is being depressed.
Speed adjusting
You can select the tool speed by tapping the main
power button. Each time you tap the main power button,
the level of speed will change.
1
► 1. Speed indicator 2. Main power button
Speed indicator
1
Automatic Torque Drive Technology
When you turn on the Automatic Torque Drive
Technology (ADT), the tool runs at optimum rotation
speed and torque for the condition of grass being cut.
To start ADT, press and hold the reverse button until
the ADT indicator turns on. After that, tap the main
power button to select the cutting tool attached to the
tool. Light the lamp beside
blade,
To stop ADT, press and hold the reverse button until the
ADT indicator turns off.
4
► 1.
4. Main power button 5. Reverse button
11 ENGLISH
1
2
Mode
High
Medium
Low
marking to select nylon cutting head.
1
2
marking 2. marking 3. ADT indicator
Rotation speed
0 - 7,000 /min
0 - 5,500 /min
0 - 4,600 /min
marking to select cutter
3
5