Finishing The Installation; Installing The Adapter Plate - Modern Forms Axis 52 Flush Installation Instructions Manual

7. Finishing the Installation

1. Secure all wire connections with supplied wire ties to assist in canopy
installation.
2. Tuck connections neatly into ceiling outlet box.
3. Remove the motor from the hook on the mounting bracket. Slide the
motor up to the mounting bracket and place the key hole on the motor
over the screw of the mounting bracket (Fig. 7).
4. Turn motor until it locks in place at the narrow section of the
key holes.
NOTE: Make sure the receiver sits flat and does not interfere with
the hook.
5. Align the circular hole on canopy with the remaining hole on the
mounting bracket. Secure by tightening the two screws previously
loosened and the two screws previously removed.
6. Raise up trim ring and line up the 4 tabs with the 4 grooves on the
mounting bracket. Once lined up, slide the trim ring and secure it to
the canopy until snug.

8. Installing the Adapter Plate

1. Remove one of the three mounting plate screws from the
mounting ring and loosen the other two screws (do not remove).
2. Place the key holes in the mounting plate over the two screws
previously loosened from the mounting ring. Turn the mounting
plate until the adapter plate locks in place at the narrow section
of the key holes (Fig. 8).
3. Tighten the two mounting ring screws previously loosened and
the one previously removed to secure adapter plate.
20 Axis Flush Instructions
F H- W 1 8 0 3 - 5 2