RedMax GZ360 Operator's Manual page 3

1. Chain brake and front hand guard
2. Felling direction mark
3. Air purge bulb
4. Air filter cover
5. Choke control
6. Rear handle
7. Information and warning decal
8. Start/stop switch
9. Fuel tank
10. Adjuster screws carburetor
11. Starter rope handle
12. Starter housing
13. Chain oil tank
14. Right hand guard
15. Spark plug cap/spark plug
16. Muffler
17. Oil pump adjustment screw
18. Chain catcher
19. Throttle trigger lockout
20. Front handle
21. Saw chain
22. Bar tip sprocket
23. Guide bar
24. Spiked bumper
25. Chain tensioning screw
26. Product and serial number plate
27. Clutch cover
28. Throttle trigger
29. Transportation guard
30. Combination wrench
31. Box spanner
32. Operator's manual
33. Brake band
34. Air filter
35. Vibration damping system, 3 units
Symbols on the product
Careless or incorrect use of this product can
result in serious or fatal injury to the operator
or others.
Read the operator's manual carefully and
make sure you understand the instructions
before you use this product.
Always wear approved protective helmet,
approved hearing protection and protective
goggles or a visor.
Both of the operator's hands must be used
to operate the chainsaw.
1086 - 002 - 15.10.2019
Never operate the chainsaw holding it with
one hand only.
Never let the guide bar tip come in contact
with any object.
Warning! Kickback may occur when the
nose or tip of the guide bar touches an
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause serious
personal injury.
Chain brake, activated (right). Chain brake,
not activated (left).
Choke lever in "open position"
Choke lever in "closed position"
Air purge.
Refuelling.
Chain oil fill.
Adjustment of the oil pump.
XX
Computed kickback bar stopping angle
without actuated chainbrake, CKA wob.
XX
Computed kickback bar stopping angle with
actuated chainbrake, CKA wb.
yyyywwxxxxx
The rating plate showing
serial number. yyyy is the
production year, ww is the
production week.
3