Changing Your Carbon Filter; Reset Your Carbon Filter Life - Dyson purifier big+quiet formaldehyde User Manual

Changing your carbon filter

The MyDyson™ app and the LCD screen will alert you when your filter life is
running low. Replacements are available to buy on www.dyson.com
Remove the conic amplifier
Slide the Release button on the back of the conic amplifier to unlock.
Lift the conic amplifier off your machine.
Lift the outer cover off the base of your machine.
Remove the filter
The carbon filter is wrapped around the central body of your machine.
Pull each of the four clips towards you to release the filter.
Dispose of the filter.
Install a new filter
Remove your replacement filter from any packaging.
Wrap the filter around the base of your machine, fit the clips in
position and push each one to secure the filter.
Place the outer cover and HEPA filter back in position on the base of
your machine.
Place the conic amplifier on your machine and rotate until it clicks
securely in position.
Plug in and switch on, and reset your filter life.

Reset your carbon filter life

It's important to reset your filter life after you have replaced your filter.
Press and hold the down airflow direction button on the remote control.
The LCD screen on your machine will count down from five, until a tick
appears on the screen.
The filter life has been reset and your machine is ready to use.
Position and twist the
conic amplifier on to the
machine. A click
indicates a secure lock.
Place the outer cover
and HEPA filter back in
position on the base of
your machine.
5
sec
Sideways green arrow
indicates release switch to
open the purifier, for access
to change the carbon filter.
Upward green arrows indicate
direction to lift the conic
amplifier, HEPA filter and
outer cover off.
The user should
pull each of the four
clips towards them
to release the filter
from the body of the
purifier. Green arrows
indicate the direction
to remove the filter
from the purifier.
Wrap carbon filter
around central body of
machine, as indicated
by green arrows. Use
the clips to secure into
position.
Holding down the
airflow direction button
on the right hand side
of the remote control
for 5 seconds.