Table of Contents
Advertisement
Inspecting the roller driver
Model
RFW 0,5
RFW 1
RFW 2
RFW 3
RFW 5
Fig. 6: Thickness of the loop
Wear measurement and replacement of guide rollers
Model
RFW 0,5
RFW 1
RFW 2
RFW 3
RFW 5
Fig. 7: Diameter of guide roller (running surface) C
The guide rollers must be replaced in the event of wear
to the limit values (see table, C).
ATTENTION!
Only use original parts from the manufacturer as
spare parts.
10
9
The use of the roller driver is possible after: UVV
"Winches, lifting and pulling equipment" BGV D8 (VBG
8), UVV "Cranes" BGV D6 (VBG 9)
Inspection by a specialist prior to initial commissioning
and after major changes when used in accordance with
BGV D8 § 23 (VBG 8 § 23)
Testing in accordance with BGV D6 § 25 (VBG 9 § 25)
by an authorised expert before initial commissioning
D [mm]
and after major modifications.
Limit value
11,0
Periodic inspections of equipment, cranes and suppor-
ting structures by a specialist once a year. In severe
15,0
operating conditions, e.g. frequent operation at full load,
18,0
dusty or aggressive environment, high switching fre-
quency, high duty cycle, test distances must be shor-
23,0
tened.
25,0
Expert
Specialists are customer service fitters of the manufactu-
The inspection shall be documented in an inspection
book.
The test is essentially a visual and functional test. It ex-
tends to the inspection of the condition of the com-
ponents and equipment, the completeness and effec-
tiveness of the safety equipment and the completeness
of the inspection book.
C [mm]
10 Disposal, reusing used machines
Grenzwert
49,5
In your own interest and to protect the environment
make sure that all machine components are exclusively
63,5
disposed of in as intended and permitted.
75,0
10.1 Decommissioning
94,0
Disused machines must be decommissioned immedi-
114,0
ately to prevent misuse at a later point and putting the
environment or persons at risk.
Step 1: Remove all environmentally hazardous process-
Step 2: If necessary, disassemble the machine into as-
Step 3: The machine components and processing mate-
Inspecting the roller driver
for the testing of cranes, only the experts au-
thorised by the employers' liability insurance
associations are considered in addition to the
TÜV experts.
rer or specially trained technical personnel.
ing materials from the used machine.
semblies and components that are easy to han-
dle and suitable for recycling.
rials must be disposed of using the intended
disposal methods.
RFW-Series | Version 1.01
Advertisement
Table of Contents
