Cleaning And Maintenance - Dometic 5 Series Installation Manual

Cleaning and maintenance

D+ (RM5385 only)
In automatic mode, the refrigerator selects the most favourable mode available. The
refrigerator is only operated with direct current when the vehicle engine is running.
The electronics of the refrigerator uses the signal D+ from the light system to detect
the running engine.
➤ Connect the D+ connection to the controls (fig. g D, page 14) with the respec-
tive terminal of the vehicle.
S+ (RM5385 only)
In automatic mode, the refrigerator is first powered with DC power from
the vehicle's own solar system. The refrigerator electronics uses the S+ signal of the
solar charge controller to detect a solar system. The solar charge controller must
have an AES output.
➤ Connect the S+ connection on the controller (fig. g E, page 14) to the respec-
tive terminal of the solar charge controller.
Suitable solar charge controllers are available from specialist dealers.
The manufacturer recommends, for example:
• Büttner MT 300-S
(www.buettner-elektronik.de)
• Votronic MPP 240 Duo Digital
(www.votronic.de)
10 Cleaning and maintenance
!
WARNING!
Always disconnect the refrigerator from the mains before you clean and
service it.
A
NOTICE! Beware of damage
• Do not allow grease or oil to come into contact with the door seal.
• Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the refrigerator.
➤ Occasionally clean the refrigerator interior and exterior with a damp cloth.
➤ Make sure that the air vents on the refrigerator are free of any dust and dirt so that
heat can be released and the refrigerator is not damaged.
30
RM53xx
EN