Table of Contents
Advertisement
10. Troubleshooting &
FAQs
10.1 Troubleshooting
This page deals with problems that can
be corrected by a user. If the problem
still persists after you have tried these
solutions, contact Philips customer
service representative.
Common Problems
No Picture (Power LED not lit)
•
Make sure the power cord is
plugged into the power outlet and
into the back of the display.
•
First, ensure that the power button
on the front of the display is in the
OFF position, then press it to the ON
position.
No Picture (Power LED is White)
•
Make sure the computer is turned
on.
•
Make sure the signal cable is
properly connected to your
computer.
•
Make sure the display cable has no
bent pins on the connect side. If yes,
repair or replace the cable.
•
The Energy Saving feature may be
activated
Screen says
•
Make sure the display cable
is properly connected to your
computer. (Also refer to the Quick
Start Guide).
•
Check to see if the display cable has
bent pins.
•
Make sure the computer is turned
on.
Visible signs of smoke or sparks
•
Do not perform any troubleshooting
steps
•
Disconnect the display from mains
power source immediately for safety
•
Contact with Philips customer service
representative immediately.
Imaging Problems
Image appears blurred, indistinct or too
dark
•
Adjust the contrast and brightness
on On-Screen Display.
An "after-image", "burn-in" or "ghost
image" remains after the power has
been turned off.
•
Uninterrupted display of still or
static images over an extended
period may cause "burn in", also
known as "after-imaging " or "ghost
imaging", on your screen. "Burn-in",
"after-imaging", or "ghost imaging"
is a well-known phenomenon in
LCD panel technology. In most cases,
the "Burn-in" or "after-imaging"
or "ghost imaging" will disappear
gradually over a period of time after
the power has been switched off.
•
Always activate a moving screen
saver program when you leave your
display unattended.
•
Always activate a periodic screen
refresh application if your LCD
display will display unchanging static
content.
•
Failure to activate a screen saver, or
a periodic screen refresh application
may result in severe "burn-in" or
45
Advertisement
Table of Contents
