Table of Contents
Advertisement
4
RJ45 driver installation
You can find the "LAN Drivers" from
Philips website support page.
Please follow the steps for the
installation:
1. Install the LAN driver that matches
your system.
2. Double click driver to install, and
follow Window's instructions to
proceed with installation.
3. It will show "success" when the
installation is finished.
4. You must reboot your computer
after the installation has completed.
5. Now you will be able to see "Realtek
USB Ethernet Network Adapter"
from your program installed list.
6. We recommend to periodically visit
the above web link to check for the
availability of the most updated
driver.
Note
Please contact Philips service hotline for
Mac address clone tool as necessary.
5
USB hub
To comply with International energy
standards, the USB hub/ports of this
monitor are disabled during Standby
and Off modes.
Connected USB devices will not work in
this state.
To permanently put the USB function
in "ON" state, please go to OSD Menu,
then select "USB standby mode", and
switch it to "ON" state. Somehow if your
monitor reset to factory setting, ensure
to select "USB standby mode" to "ON"
state in OSD menu.
6
USB charging
This monitor has USB ports capable
of standard power output including
some with USB Charging function
(identifiable with power icon
can use these ports to charge your
Smart phone or power your external
HDD, for example. The monitor must be
powered ON at all times to be able to
use this function.
Some select Philips monitors may not
Power or Charge your device when it
enters to "Sleep/Standby" mode (White
power LED blinking). In that case, please
enter to OSD Menu and select "USB
Standby Mode", then, turn the function
to "ON" mode (default=OFF). This will
then keep the USB power and charging
functions active even when the monitor
is in sleep/Standby mode.
Note
If you Turn OFF your monitor via the
power switch at any given time, all the
USB ports will power OFF.
Warning
USB 2.4Ghz wireless devices, such
as, wireless mouse, keyboard, and
headphones, maybe have interference
by USB3.2 or higher version, the high-
speed signal devices, which may result
in a decreased efficiency of the radio
transmission. Should this happen,
please try the following methods to help
reduce the effects of interference.
8
). You
Advertisement
Table of Contents
