Table of Contents
Advertisement
Step 6: Flush faucet
A
NOTE
: Please make sure washer is
installed attaching sprayer to hose.
9
Pull the hose assembly out of the spout and
remove the sprayer (A) by unscrewing it
from the hose in a counterclockwise direction.
Be sure to hold the end of the hose down into
the sink and turn the faucet on to the warm
position where it mixes hot and cold water.
Flush the water lines for one minute. This
ushes away any debris that could cause
damage to internal parts. Check for leaks.
Re-tighten any connections if necessary, but
do not overtighten. Reinstall the sprayer (A)
by hand tightening it back onto the sprayer
hose.
After installation is completed, turn on the
hot and cold water supplies. Check for leaks.
Advertisement
Table of Contents
