NEC MultiSync XG85RP Operation Manual page 3

Important Safeguards
The following are important safety instructions designed to ensure the long life of
your projector and to prevent fire and shock hazards. Be sure to read these safety
instructions carefully and follow all warnings given below.
Installation
The projector must be installed by trained personnel.
Place the projector on a flat, level surface and in a dry area free from dust and
moisture. Do not place the projector in direct sunlight, near stoves or other heat
radiating appliances. Smoke, steam and exposure to direct sunlight could adversely
affect the internal components. Avoid rough handling when moving your equipment
as a strong shock could damage its internal components.
Power supply
The XG85RP/XG85RPW and XG135RP projector are designed to operate on 120 V
60 Hz AC power supply. Make sure your local power supply matches these
requirements before operation.
Handle the power cord carefully and avoid excessive bending. A damaged cord may
cause electric shock or fire. If the projector is not to be used for an extended period,
remove the plug from the power outlet.
Cleaning
Always unplug the projector from the wall outlet before cleaning.
Cleaning the cabinet and front panel periodically with a soft cloth. If heavily stained,
use a mild detergent solution. Never use strong detergents or solvents such as alcohol
or a thinner to clean your projector.
Cleaning the screen
Clean the screen by rubbing lightly with a dry or slightly damp cloth. When the screen
becomes dirty or badly or stained, use a mild detergent solution.
NOTE: Never attempt to remove dirt from the grooves by cleaning the grooves
individually, as this will damage the screen.
Fire and Shock Precautions
Adequate ventilation must be provided to prevent heat build-up inside the projector.
Make sure the ventilation holes are unobstructed.
Keep the inside of the projector free from foreign objects, such as paper clips, nails,
paper, etc. Do not attempt to retrieve such objects yourself or insert metal objects such
as wire and screw-drivers inside the projector. If a hazardous object falls inside the
projector, unplug it immediately and call a qualified electrical repairman for removal.
Do not set liquids on top of the projector.
3
INTRODUCTION