Table of Contents
Advertisement
ELECTRICAL GROUNDING INSTRUCTION:THIS APPLIANCE IS EQUIPPED WITH A THREE-
PRONG (GROUNDING) PLUG FOR YOUR PROTECTION AGAINST SHOCK HAZARD AND SHOULD
BE PLUGGED DIRECTLY INTO A PROPERLY GROUNDED THREE-PRONG RECEPTACLE.
NOTE: #PESBR084 Blower Motor
Rating: 120 volts/60HZ/1.1 Amps.
See Figure 9, page 18 for wiring diagram.
NOTE: For convenience, allow licensed electrician to install properly grounded
3-plug receptacle near unit.
To remove or replace blower, open lower louvered access door. Room air blower is located at rear of unit in bottom
chamber. Remove two (2) hex head screws holding motor and motor bracket to outer bottom of unit. Unhook two
motor wires and remove motor from unit. Next remove (2) screws that fasten motor bracket to motor. Locate motor
bracket onto new motor in same position as with old motor. Using two (2) hex head screws fasten bracket to new
motor. Place new motor into lower compartment.
NOTE: Make sure motor opening 1"x 5" is behind inner wall of stove and not touching any metal. Fasten new
motor and bracket to motor support on bottom of unit. Hook motor wires as shown in the diagram on page 18.
Installation and repairs should be performed by a qualified service person. The appliance should be inspected before
use and at least annually by a professional service person. More frequent cleaning may be required due to excessive lint
from carpeting, bedding material, etc. It is imperative that control compartments, burners and circulating air
passageways of appliance be kept clean.
Your stove is equipped with a automatic thermostat. When stove gets hot enough, thermostat will activate room air
blower. Set fan speed according to desired heat output using rheostat.
LOWER ACCESS DOOR
WARNING:
ROOM BLOWER INSTALLATION
BLOWER OPERATION INSTRUCTIONS
Page 19
BLOWER MOTOR AND MOTOR BRACKET
MOTOR BRACKET SCREWS
RHEOSTAT
Advertisement
Table of Contents
