Connecting The Wireless Temperature Sensor To The Control Panel; Cleaning - Siemens EX9 KX Series Instruction Manual

Fitting the wireless temperature sensor
Attach the temperature sensor to the silicone patch and
align it correctly.
Notes
Make sure that the silicone patch is completely dry
■
before attaching the temperature sensor.
Position the cookware in such a way that the
■
temperature sensor is pointing towards the outer
side of the hob.
To prevent overheating, the temperature sensor
■
must not be pointed towards another item of
cookware that is hot.
Remove the temperature sensor from the saucepan
■
after cooking. Store it in a clean, safe place away
from sources of heat.
You can use up to three temperature sensors at the
■
same time.
Connecting the wireless temperature sensor
to the control panel
To connect the wireless temperature sensor to the
control panel, follow the instructions below:
Open the docking menu.
1.
Open the basic settings and select "Cooking sensor"
2.
from the menu.
Select the Add a new cooking sensor option.
3.
Press the » symbol on the wireless temperature
sensor within 30 seconds.
After a few seconds, the status of the connection
between the temperature sensor and the control
panel will appear on the display.
The cooking functions are made available once the
cooking sensor has been connected to the control
panel correctly.
Notes
If there is a fault with the cooking sensor, the
■
connection may not be established correctly for the
following reasons:
– Bluetooth communication error.
– The symbol on the cooking sensor was not
pressed within 30 seconds.
– The battery in the cooking sensor is drained.
Reset the cooking sensor and repeat the connection
procedure.
If the temperature sensor and the control panel are
■
not connected correctly due to a transmission error,
repeat the connection procedure.
If the display continues to indicate a connection
error, contact our technical after-sales service.
Wireless temperature sensor
Resetting the wireless temperature sensor
»
Touch the symbol on the cooking sensor for
1.
approximately 8-10 seconds.
While you are doing this, the temperature sensor's
LED indicator will light up three times. When the LED
lights up for the third time, it will start to reset the
temperature sensor. Stop touching the symbol when
this happens.
Once the LED goes out, this means that the wireless
temperature sensor has been reset.
Repeat the connection procedure.
2.

Cleaning

Do not clean the wireless temperature sensor in the
dishwasher.
Temperature sensor
Clean the temperature sensor with a damp cloth. Never
clean it in the dishwasher. Do not immerse it in water or
clean it under running water.
Remove the temperature sensor from the saucepan
after cooking. Store it in a clean, safe place (such as in
its packaging) away from sources of heat.
Silicone patch
Clean and dry before attaching to the temperature
sensor. Dishwasher safe.
Note:
Cookware with the silicone patch must not be left to
soak for long periods in soapy water.
Temperature sensor window
The sensor window must always be clean and dry.
Proceed as follows:
Remove dirt and oil splatters regularly.
■
Use a soft cloth or cotton buds and window cleaner
■
for cleaning.
Notes
Do not use abrasive cleaning agents such as
■
scouring pads, scrubbing brushes or cream
cleaners.
Do not touch the sensor window with your fingers.
■
This may make it dirty or scratch it.
en
37