Toyota VENZA 2010 Manual page 455

Hide thumbs Also See for VENZA 2010:

Table of Contents

Programming a rolling code system

If your device is rolling code equipped, follow the steps under the

heading "Programming HomeLink

steps listed below.

Locate the learn button on the ceiling mounted garage door

opener motor. The exact location and color of the button may

vary by brand of garage door opener motor.

Refer to the operation manual supplied with the garage door opener

motor for the location of the learn button.

Press the learn button.

Following this step, you have 30 seconds in which to initiate step 3

Press and hold the vehicle's programmed HomeLink

for 2 seconds and release it. Repeat this step once again. The

garage door may open.

If the garage door opens, the programming process is complete. If

the door does not open, press and release the button a third time.

This third press and release will complete the programming process

by opening the garage door.

The ceiling mounted garage door opener motor should now recog-

nize the HomeLink

Repeat the steps above to program another rolling code sys-

tem for any of the remaining HomeLink

VENZA_U (OM73007U)

" before proceeding with the

signal and operate the garage door.

3-8. Other interior features

Show Quick Links

Table of Contents