Yamaha XTZ690 Owner's Manual page 65

Recommended engine oil:
See page 8-1.
Oil quantity:
Without oil filter cartridge replace-
ment:
2.30 L (2.43 US qt, 2.02 Imp.qt)
With oil filter cartridge replacement:
2.60 L (2.75 US qt, 2.29 Imp.qt)
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
 In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
 Make sure that no foreign mate-
rial enters the crankcase.
Periodic maintenance and adjustment
11. Check the O-ring for damage, and
replace it if necessary.
1. Engine oil filler cap
2. O-ring
ECA11621
12. Install and tighten the engine oil
filler cap.
13. Install the cowling A.
14. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
TIP
After the engine is started, the engine
oil pressure warning light should go off.
6-13
NOTICE
If the oil pressure warning light flick-
1
ers or remains on even if the oil level
is correct, immediately turn the en-
gine off and have a Yamaha dealer
check the vehicle.
15. Turn the engine off, wait a few
minutes for the oil level to settle for
2
an accurate reading, and then
check the oil level and correct it if
necessary.
ECA20860
6