Yamaha XTZ690 Owner's Manual page 29

Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch " "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
starting the engine. Set this switch
to " " (stop) to stop the engine in case
of an emergency, such as in the event
of an overturn or if the throttle is stuck.
Start switch "
Push this switch to crank the engine
with the starter. See page 5-2 for start-
EAU12461
"
ing instructions prior to starting the en-
gine.
". When
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
EAU12501
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
Instrument and control functions
EAU12664
/ "
NOTICE
" (run) before
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU12713
"SELECT" switch
"
This switch has the same functions as
the bottom set button of the Multi-
function meter unit.
See "Multi-function meter unit" on
page 3-6 for detailed information.
EAU12735
" posi-
3-14
ECA10062
3
EAUM4090