Mounting Installation - Fisher & Paykel CHAUFFE-PLATS 9 Series Installation Manual/User Manual

INSTALLATION INSTRUCTIONS

MOUNTING INSTALLATION

The lower rear corners of the cabinet need to provide proper support to the back of the warming
drawer and the anti-tip mounting clips. A 120 volt AC outlet should be located no further than 36 inches
from the back center of the warming drawer.
The bottom rear section of the cabinet should be made of solid plywood or two 2x4 beams.
It holds the anti-tip mounting clips and supports the weight of the warming drawer, which is 90 lbs.
(see Figs. 5 and 6). If two 2x4 beams are used, the distance between their centers must be 20" to be
able to secure the Warming Drawer.
STEP 1
Use the screws provided and attach the mounting clips. They must be installed for anti-tip safety to the
bottom support at the back. See placement dimensions in the figures below (see Figs. 5 and 6).
STEP 2
Plug power cord into AC outlet. Slide the body onto the anti-tip mounting clips (see Fig. 6).
STEP 3
Use the two supplied 1-1/2" long screws through the two embossed holes (see Fig. 7) to secure the
front of the warming drawer.
21-1/2"
Fig. 5
Slide body
on to anti-tip
mounting clips
mounting clips
7
US
CA