Table of Contents
Advertisement
INSTALLATION BELOW A COUNTERTOP
Install 2x4 or 2x2
Anti-Tip Block Against
Rear Cabinet Wall 9"
From Floor to Bottom
Electrical
of Block
Outlet 16"
Max. From
Left Side
23-1/2" Min.
When installed, the front face of the drawer will be
nearly flush with adjacent cabinetry doors.
Drawer overlaps will conceal cut edges on all sides of
the opening.
The rough opening for the drawer must be:
– Depth: 23-1/2" min. from inside back to front of
cabinet frame.
– Width: 25-1/2" for 27" wide models,
28-1/2" for 30" wide models.
– Height: 9-1/4".
5" min. above floor or 1" above toekick. 23-1/4"
from floor to bottom of cutout is recommended for
under countertop installation.
Installation below a cooktop:
Warming drawers are approved for installation below
only certain specified cooktop models. See the label
attached to the top of the warming drawer for approved
models. A solid barrier and air gap between cooktop and
warming drawer is required. See NOTE above.
8
Installation Preparation
Electrical Outlet
Flush With Side of
Cabinet 7" Max.
7"
9"
Solid Barrier
1/4"
Air
Gap
Install a Solid Barrier
and a 1/4" Air Gap
Above Warming Drawer
Electrical Outlet 42"
Max. From Right Side
1-1/2" Cabinet Top
25"
Install a Solid Barrier
Below a Cooktop
See Note
1" Min.*
9-1/4"
A
*NOTE: When installing the warming drawer below a
cooktop, a solid barrier must be installed at least 1" from
the lowest point of the bottom of cooktop burner box to
the top of cutout. Use any solid material such as 1/4"
thick plywood. Allow at least 1/4" air gap between the
barrier and the top of the warming drawer. See label on
top of the warming drawer for approved cooktop models.
Installation below a cabinet drawer:
The warming drawer may be installed beneath a cabinet
drawer. In this installation, a solid barrier should be
installed above the warming drawer to block access. Use
any solid material such as 1/4" thick plywood. Allow at
least 1/4" air gap between the barrier and the top of the
warming drawer. Observe the 5" min. above the floor or
1" above the toekick minimum installation height.
NOTE: If you are installing in frameless cabinets, it may
be necessary to install 1/2" wide cleats to accept drawer
mounting screws. See drawer to find exact locations of
mounting screws.
Side to Side Installation:
Install two warming drawers in separate cutouts.
Allow 2" min. between cutouts.
Side to Side Installation
36"
Countertop
Height
Dimensions
Models
ZW9000
28-1/2"
ZJ7000
25-1/2"
2"
Min.
A
31-10700-6
Advertisement
Table of Contents
