Table of Contents
Advertisement
STEP 4 SECURE CUSTOM PANEL
TO METAL MOUNTING
PANEL
Lay the custom panel, appearance side down, on a
clean surface.
Remove all tape and packing material from the metal
panel.
Place the flat side of the metal panel onto the back
side of the custom panel, with the mounting flanges
facing up.
Align the lamp hole in the panel with the mounting
panel.
Confirm squareness and correct position of the metal
panel to the custom panel.
STEP 5 FOR PANELS LESS THAN
3/4" THICK
Separate the custom panel and metal panel.
Apply a few horizontal beads of adhesive to the metal
panel. Avoid adhesive within 1" of lamp hole area and
outer edges.
STEP 5A FOR PANELS LESS THAN
3/4" THICK
Separate the custom panel and metal panel.
Use the metal panel as a template. Position the metal
panel over the back side of the custom panel and
drill pilot holes. Drill pilot holes sized to match screws
being used (screws not provided).
NOTE: Select screw length carefully to avoid
penetration of the finished side.
STEP 6 INSTALL LAMP JEWEL
Turn the assembly appearance side up.
Use plastic to wood adhesive to secure the lamp
jewel to the front of the wood panel. On the side with
the bulge, (see illustration) apply a small bead of
adhesive around the outside edge. Place the jewel
into the drilled hole.
This Side
Appearance
Against
Side
Wood
31-10700-6
Installation
STEP 7
A custom handle (not supplied) may be installed.
Drill pilot holes through the front of the custom panel
and through the metal panel to match the chosen
handle.
NOTE: The handle screws should be installed through
the metal panel, the custom panel and into the custom
or original handle.
STEP 8 I
Determine which holes in the metal panel line up with
the holes in the exposed drawer front and marked the
screw hole locations onto the custom panel.
Drill 1/8" deep holes into the custom panel for
clearance to the #6 screws. The #6 screws will
extend into the custom panel slightly.
Using the #6 screws supplied in the bag, install the
custom panel assembly to the exposed drawer front
with seven screws.
The original #8 screws are not needed.
Insert
NOTE: Product improvement is a continuing endeavor at
Jewel
General Electric. Therefore, materials, appearance and
specifications are subject to change without notice.
REINSTALL ORIGINAL
HANDLE OR OPTIONAL
CUSTOM HANDLE
NSTALL ASSEMBLED PANEL
TO THE DRAWER
Custom Handle
or Original Handle
11
Advertisement
Table of Contents
