Volvo V50 2010 Owner's Manual page 152

06 Starting and driving
Alcoguard*
Bypass function will then be possible, see
page 152 section Emergency situation.
The message can be cleared by pressing the
send button (3) once. Otherwise it goes out on
its own after approx. 2 minutes but then reap-
pears each time the engine is started - only
recalibration at a workshop
sage permanently.
Cold or hot weather
The colder the weather the longer it takes
before the Alcolock is ready for use:
Temperature (ºC)
+10 — +85
–5 — +10
06
–40 — –5
At temperatures below -20 ºC or above
+60 ºC the Alcolock requires additional power
supply. The display shows
INSERT POWER CABLE
nect the power supply cable from the glovebox
and wait until indicator lamp (6) is green.
1 An authorised Volvo workshop is recommended.
*
152
Option/accessory, for more information, see Introduction.
In extremely cold weather the heating time can
be reduced by taking the Alcolock indoors.
Emergency situation
In the event of an emergency situation, or if the
Alcolock is out of order or has been removed,
it is possible to bypass the Alcolock in order to
1
can clear the mes-
drive the car.
NOTE
All Bypass activation is logged and saved in
memory, see page 12 in the section,
Recording data.
Maximum heat-
After the Bypass function has been activated
ing time (sec-
the display shows
onds)
ENABLED
can only be reset by a workshop
10
The Bypass function can be tested without the
60
error message being logged - in which case,
carry out all the steps without starting the car.
180
The error message is cleared when the car is
locked.
When the Alcolock is installed, either the
ALCOGUARD
Bypass or Emergency function is selected as
. In which case, con- the bypassing option. This setting can be
changed afterwards at a workshop
ALCOGUARD BYPASS
the whole time while driving and
1
.
1
.
Activating the Bypass function
•
Depress and hold the left-hand stalk
switch READ button and the button for
hazard warning flashers simultaneously for
approx. 5 seconds - the display first shows
BYPASS ACTIVATED WAIT 1 MINUTE
ALCOGUARD BYPASS
and then
ENABLED
- after which the engine can be
started.
This function can be activated several times.
The error message shown during driving can
1
only be cleared at a workshop .
Activating the Emergency function
•
Depress and hold the left-hand stalk
switch READ button and the button for
hazard warning flashers simultaneously for
approx. 5 seconds - the display shows
ALCOGUARD BYPASS ENABLED
the engine can be started.
This function can be used once, after which a
reset must be made at a workshop
and
1
.