Table of Contents
Advertisement
7.8 Ignition module and flywheel
– refitting
1
Fit the flywheel on the crankshaft journal. Turn the
flywheel so that the key lines up with the keyway in
the shaft.
Fit the nut on the shaft and tighten to a torque of
17-20 Nm. (see figure 11)
2
To refit the ignition module proceed as follows:
Turn the flywheel so that the magnets are in line
with the ignition module. Fit the ignition module with
the plastic feeler gauge (502 51 34- 02) held in posi-
tion at the same time, without tightening the bolts.
Fit the earth cable (black) (A). Set a distance of 0.3
+/- 0.1 mm, between the ignition module and mag-
net. The measurement applies to the two lowest
lugs on the ignition module. Tighten the screws,
tightening torque 4–6 Nm. Fit the blue cable on the
ignition module. (see figure 12)
3
Then refit:
•
cable guide and press the leads into position
•
HT lead
•
starter assembly, tighten to a torque of 2.5–3.5
Nm
•
cylinder cover
When replacing the cables, they are fitted on the
stop switch as shown in middle figure on the pre-
vious page.
Fig 11
Fig 12
Repair instructions
29
English –
Advertisement
Chapters
Table of Contents
