Table of Contents
Advertisement
Identifying the parts
#¶
#•
#ª
$º
$¡
$™
$£
$¢
$∞
#¶ Eyecup
#• VIEW FINDER jack (p. 20)
# ªS VIDEO OUT jack (p. 34)
$ ºRFU DC OUT jack (p. 35)
$ ¡ DV OUT jack (p. 74)
Connect DV products using the connecting
DV cable.
$ ™ CH-1 LINE/MIC switch (p. 65)
Set to change the audio source using a CH-
1 input.
$ £CH-1 ATT (REAR) switch (p. 67)
Set ON to attenuate the CH-1 input
microphone level.
$ ¢CH-2 LINE/MIC switch (p. 65)
Set to change the audio source using CH-2
input.
$∞ CH-2 ATT (REAR) switch (p. 67)
Set ON to attenuate the CH-2 input
microphone level.
$ §MIC (PLUG IN POWER) jack (p. 28)
Connect an external mini jack type
microphone (not supplied). This jack also
accepts a "plug-in-power" microphone.
When using this jack, set LINE/MIC to
MIC FRONT.
8
$¶DIRECTION SELECT switch (p. 28)
Set to change the directionality of the built-
in microphone.
$ •Built-in microphone (p. 65)
$ ª Microphone wind screen screw
Loosen to remove wind screen.
%º MIC switch (p. 67)
Set ATT to attenuate the built-in
microphone and external microphone
connected to MIC (PLUG IN POWER) level.
% ¡Lens hood screw
% ™ Power zoom button (p. 30)
%£ PHOTO button (p. 46)
Press to shoot in photo mode.
%¢ STANDBY (LOCK/STANDBY/PHOTO
STANDBY) switch (p. 26)
% ∞ START/STOP button (p. 26)
%§ BUILT-IN MIC switch (p. 67)
If recording when there is a loud wind using
the built-in microphone, set to WIND.
% ¶ AUDIO OUT/VIDEO OUT jacks (p. 34)
% • DC IN jack (p. 38)
DSR-200P CE 3-858-622-12(1). E
$§
$¶
$•
$ª
%º
%¡
%™
%£
%¢
%∞
%§
%¶
%•
Advertisement
Table of Contents
