Advertisement
10
Powering the Access Point
The AP can be powered using:
• 44 to 57 VDC power via the VDC port, using Cisco Power Adapter AC/DC AIR-PWR-D=.
• Power-over-Ethernet (PoE) from the Ethernet cable, from an external power source such as the
Cisco Power Injector AIR-PWRINJ5= or AIR-PWRINJ6=.
• Any 802.3at (25.5 W) or 802.3af (15.4 W) Ethernet switch.
The PoE-Out port (labeled PSE) provides 802.3af power when the AP is powered by Cisco local
power supply (AIR-PWR-D=), ~6.5W power when the AP is powered by 802.3at power, and no
power output when the AP is powered by 802.3af power.
If the AP is mounted on a horizontal flat surface, such as on a table, using the cradle mount kit, then
you can route the DC power cord as shown in
Figure 15
Routing the DC Power Cord when AP is Table-Mounted
Figure
15.
29
Advertisement
