Table of Contents
Advertisement
Important:
Hold the SSD module by its edge, and do not touch the gold contacts.
4 Start from the first slot. Insert your SSD module into the empty slot:
a Align the notch on the gold contacts of the SSD module with the notch on the empty slot. Insert the module
into the slot. Make sure the module is properly inserted.
b Push the lever outwards with your finger, as shown below. While holding the lever, push down the SSD
module, and then release the lever to secure the SSD module. Put the lids back in their places.
5 Reconnect the cables you removed in step 1, and then press the power button to turn on your DiskStation.
6 Repeat the steps above to install the another SSD module into the second slot if needed.
To remove the M.2 NVMe SSD module:
1 Shut down your DiskStation. Disconnect all the cables connected to your DiskStation to prevent any possible
damages.
2 Push the lever outwards with your finger. The module will pop up and be released from the slot.
3 Hold the SSD module and remove it from the slot. Put the lids back in their places.
4 Reconnect the cables you removed in step 1. Now you may turn on your DiskStation.
10 Chapter 2: Hardware Setup
Advertisement
Table of Contents
