Pro-Team AviationVac Operating Manual page 5

INTRODUCTION
ELECTRICAL
The vacuums as described in this manual, unless otherwise noted, are designed to
operate on 220VAC – 240VAC power supply at 50Hz / 60Hz. The vacuums as described
in this manual are a Class I appliance, unless otherwise noted.
The vacuum cleaners described in this manual are equipped with a thermal protection
device. The integrated thermal switch will remove power from the vacuum motor in the
event excessively high operating temperatures are detected. This condition is normally
the result of a blocked vacuum passage, clogged or full filters.
Should a thermal trip take place, immediately turn off the vacuum and inspect for a
blockage and verify the condition of the filter bag and change or empty as required.
The vacuum will require several minutes to cool down to a safe operating temperature.
When this temperature is attained, the thermal switch will reset and the vacuum will be
able to be used in a normal manner.
PROTECTIVE EARTHING INSTRUCTIONS
THESE VACUUMS MUST BE CONNECTED TO A PROPERLY EARTHED (GROUNDED)
POWER SUPPLY. If a vacuum should malfunction or stop working, earthing (grounding)
provides a path of least resistance for electrical current, thereby reducing the risk of
electrical shock. This unit is equipped with a cord that has an equipment-earthing
conductor and earthing plug. The plug must be inserted in an appropriate outlet that
is properly installed and grounded in accordance with all local codes and ordinances.
Cutting off or disabling the earthing wire or using a cord or outlet that is not properly
earthed will void the warranty on the unit, and ProTeam will accept NO liability
associated with the unit.
WARNING – Improper connection of the equipment-earthing connector conductor
can result in a risk of electrical shock. Check with a qualified electrician or service person
if you doubt that the outlet is properly earthed (grounded). Do not modify the plug
provided with the vacuum. If it will not fit the outlet, have a proper outlet installed by
a qualified electrician.
ProTeam 3